Overview
The Englander 25-CBPAH pellet stove (model ESW0020) is built around one thing: a 120 lb hopper that runs up to 76 hours between fills. It heats up to 2,200 sq ft with 11,098 to 25,122 BTU/h of heat output, burns 2 to 4.4 lb of pellets an hour, and is EPA 2020 certified at 1.47 g/h with 67.6% efficiency (HHV). Automatic ignition, a room blower, a 3" pellet vent outlet and an outside air kit in the box. Approved for mobile homes with outside air. The same stove is sold as the 55-SHPCBPAH and 55-TRPCBPAH; one owner's manual covers all three.
Who the 25-CBPAH is for
Choose the 25-CBPAH when you care more about how often you fill the stove than how hard it can push. It suits:
- Well-insulated homes, or homes where the pellet stove supplements a furnace or heat pump.
- Main living areas and open floor plans where steady, moderate heat is the goal.
- Owners who are away for long stretches and want to fill the hopper about twice a week in mild weather.
Englander's 2,200 sq ft figure is a maximum that depends on climate, insulation and layout, and the manual asks you to check it against a heat-loss calculation. Its top output of about 25,000 BTU/h is modest, so in a cold climate or a drafty house a stove with more output will serve you better (see the comparison below).
Hopper size and burn time per hopper
The hopper holds 120 lb, three 40 lb bags. Englander rates a full hopper at up to 76 hours on the lowest setting; at the highest feed rate, 4.4 lb/h, it lasts a little over a day. Real numbers depend on the pellets: Englander recommends premium-grade, 1/4" pellets from PFI-certified mills, and either softwood or hardwood pellets burn well. Low-grade, high-ash pellets fill the burn pot faster and shorten the time between cleanings. The burn pot should be emptied daily and before every start-up, and the baffle and clean-out covers checked weekly.
Heat range and efficiency
Heat output runs from 11,098 BTU/h on low to 25,122 BTU/h on high (3.25 to 7.36 kW). Tested efficiency is 67.6% (HHV) and particulate emissions are 1.47 g/h, within the EPA 2020 limit. The low end is the 25-CBPAH's strength: it idles gently on mild days without overheating the room.
Controls, ignition and power
A digital control board sets the heat range and the room blower speed; the blower always runs at or above the heat range. Press "On" and the automatic igniter lights the pellets, with normal operation in about 15 minutes. There is no thermostat or scheduling mode in the manual. The stove plugs into a standard household outlet, and Englander recommends a surge protector. If the power drops for about three minutes or less, the stove restarts on its own; after a longer outage it stays off until you press "On". Like every pellet stove, it does not run without power.
Venting
The 25-CBPAH uses 3" or 4" Type L or PL pellet vent, never B-vent or galvanized pipe. Runs up to 15 ft can be 3" pipe; longer runs, and installs above 4,000 ft altitude, need 4". The manual requires at least 36" of vertical rise so smoke can clear the stove in a power outage, and the vent may also be run through a ceiling or into an existing chimney with a suitable liner. For a typical through-the-wall install, the Vortex 3" Pellet Vent Ground Floor Kit (VOPKGF03) and the 3" stove adapter (VOP0150) cover the whole run. The Englander 25-CBPAH Complete Install Package bundles the stove, that kit and the adapter in one order. Our pellet stove venting guide covers layouts and termination clearances.
Outside air kit and mobile homes
Outside combustion air is mandatory on this stove, and the kit to connect it is included. If the connection is longer than 6 ft, uses more than two elbows or the stove is in a basement, the manual calls for 3" outside-air pipe instead of 2". In a mobile home, the stove must use the outside air kit, be bolted to the floor and grounded, and may not go in a bedroom.
Clearances and floor protection
Minimum clearances to combustibles are 0" to the rear wall, 8" to a side wall and 6" in a corner, though the vent pipe's own clearances may push the stove farther from the wall. On a combustible floor, the stove needs a non-combustible floor protector with an R-value of at least 0.2, extending 6" past the front and sides. Our 46 3/4" x 54" insulated black steel hearth pad (R-1.03) meets that requirement; plain ember pads in our hearth pad collection do not.
25-CBPAH vs. the nearest alternatives
↔ Swipe the table to see more →
| Englander 25-CBPAH | ComfortBilt Alpine HP42 | Ventis ECO-55 ST | |
|---|---|---|---|
| Heats up to | 2,200 sq ft | 2,500 sq ft | 2,000 sq ft |
| Max heat | 25,122 BTU/h output | 42,000 BTU/h | 39,260 BTU/h input |
| Hopper | 120 lb | 120 lb | 80 lb |
| Max burn time | 76 hrs | 80 hrs (low) | 70 hrs |
| Controls | Heat range + blower | Thermostat, schedule, remote | Electronic control |
The ComfortBilt Alpine HP42 has the same 120 lb hopper with more output, a remote and thermostat modes. The Ventis ECO-55 ST, built by SBI, the maker of Drolet, burns cleaner at 0.96 g/h and carries a limited lifetime warranty. For more output, the Drolet ECO-65R heats up to 2,600 sq ft from a 125 lb hopper. Compare the ship dates shown on each product page.
Why buy the Englander 25-CBPAH from StoveSource
- No Sales Tax in any state.
- Free shipping to the lower 48.
- Authorized Englander dealer, with the manufacturer's limited 5-year warranty (firebox steel, welded seams, door and hinges; 1 year on hopper, auger, burn pot, electrical parts and glass).
- Price match guarantee.
- Real help with sizing, venting and outside air: email info@stovesource.com or text 1-888-866-8206.
- Heats up to 2,200 sq ft with 11,098–25,122 BTU/h heat output
- EPA 2020 certified at 1.47 g/h average particulate emissions
- 67.6% tested efficiency (HHV)
- Massive 120 lb hopper — up to 76 hours per fill
- Pellet feed rate 2 to 4.4 lb/hr depending on setting
- Outside air kit included — outside combustion air is mandatory on this stove
- Mobile-home approved when installed with the outside air kit
- 3" Type L/PL pellet vent exhaust
- 5-year warranty on firebox steel and welded seams, 1 year on components
Installation
Clearances to Combustibles (USA)
| Rear wall | 0" |
|---|---|
| Side wall | 8" |
| Corner | 6" |
| Floor protector | Non-combustible, R-value 0.2 or higher, 6" past front and sides |
Specifications Show details Hide details
Specifications
| Fuel Type | Premium-grade wood pellets |
|---|---|
| Heating Area | Up to 2,200 sq ft |
| Heat Output | Up to 25,122 BTU/h (range 11,098 - 25,122) |
| Hopper Capacity | 120 lb |
| Maximum Burn Time | 76 hours |
| Pellet Burn Rate | 2 - 4.4 lb/h |
| Average Particulate Emissions | 1.47 g/h — EPA 2020 certified |
| HHV Tested Efficiency | 67.6% (HHV) |
| Dimensions (W x D x H) | 24 1/2" x 27" x 38" |
| Flue Outlet Diameter | 3" |
|---|---|
| Venting | 3" or 4" Type L/PL pellet vent (4" for runs over 15 ft or above 4,000 ft) |
| Outside Air Kit | Included |
| Ignition | Automatic |
| Controls | Digital control board: heat range and room blower speed |
| Mobile Home Approved | Yes (with fresh air intake) |
| Certification | EPA Certified |
| Origin | Made in USA |
| Warranty | 5 yr firebox steel, welded seams, door & hinges / 1 yr components, electrical & glass |
Shipping & Returns
Free freight shipping · Currently unavailable · curbside delivery.
Free shipping to the continental US.
Ships via LTL (Less Than Truckload) freight – carriers include XPO Logistics, Estes Express, ABF Freight, Old Dominion, and FedEx Freight. Transit time is typically 3–10 business days from ship date. The carrier will call to schedule a delivery appointment.
Remote addresses. Some rural or hard-to-access addresses carry a carrier freight surcharge. If yours does, we'll email you the exact amount for approval before your order is processed — or you can cancel for a full refund.
Curbside delivery only. The driver will lower your order to the curb or end of your driveway via liftgate. This does not include bringing the item inside, carrying up stairs, or crossing uneven terrain.
Have an appliance dolly and an extra person available on delivery day. Need inside or threshold delivery? Contact us before ordering.
Inspect before signing. Before signing the Bill of Lading (BOL), check for any visible packaging damage. Write "DAMAGED" or "Subject to inspection" on the BOL if anything looks off.
Contact us within 5 business days of delivery. Open and fully inspect your item within 48 hours.
Returns. Unused, uninstalled units in original packaging can be returned within 30 days. Appliance returns are subject to a $300 return freight charge plus a 15% restocking fee. Units that have been fired or installed cannot be returned. Accessories and parts carry a 15% restocking fee.
View full shipping policy · View return policy
Sold by StoveSource (authorized dealer). Ships directly from the brand's authorized distributor warehouse — see our Authorized Dealer page.
Frequently asked questions
Other accessories & add-ons
Blowers, screens, hearth pads and more for your stove.
3" Pellet Stove Cleaning Kit
Brush and rod cleaning kit for maintaining a 3" pellet vent system.
$145.00
Ships in 1–2 days
46 3/4" x 54" Insulated Black Steel Hearth Pad
The Floor Protection section of the 25-CBPAH manual (46319A) requires a non-combustible floor protector wit...
$369.00
Ships in 1–2 days
3" Pellet Vent Ground Floor Kit
Complete 3" pellet vent kit for a ground-floor install — everything needed to vent the stove through an ext...
$629.00
Ships in 1–2 days
DuraVent 3" Straight Pipe
Single 3" PelletVent Pro straight section — for extending or completing an existing DuraVent run.
$39.99
Ships in 1–2 days
DuraVent 3" 90° Elbow
3" PelletVent Pro 90° elbow for turning the vent run — pairs with other DuraVent components.
$99.86
Ships in 1–2 days
DuraVent 3" Tee with Clean-Out Cap
3" PelletVent Pro tee with clean-out cap for behind-the-stove vent runs — pairs with other DuraVent compone...
$135.87
Ships in 1–2 days
Replacement Door Glass with Gasket (SE36971)
Genuine SBI replacement door glass for this stove. Size: 9 1/8" W x 9 1/8" H.
$69.99
Pre-order — ships Dec 1
3" Pellet Stove Adapter
3" adapter connecting the pellet stove's flue outlet to the pellet vent pipe.
$35.00
Pre-order — ships Dec 1
Vortex 3" Pellet Vent Attic Insulation Shield (VOP0300)
Required where 3" Vortex pellet vent passes through an insulated attic.
$79.99
Pre-order — ships Dec 1Questions before you buy? Our stove experts are here to help.
Sizing for your space
Right BTU range for your sq ft and climate.
Clearance & install
Venting and clearance for your setup.
Lead time & shipping
Real ETAs and freight scheduling.
Text us a photo of your space or your old stove's label and we'll reply with the right options.
Prefer to talk? Call 1-888-866-8206 · 7 days a week · 7am–11pm ET



